Edge-lighting Sun 3 LED Components Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Edge-lighting Sun 3 LED Components. Edge Lighting Sun 3 LED Components User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
NOTE:
trim to be water proof.
Do not remove the glass retainer ring which makes the
Installation Instructions for STEP LIGHT KITS SUN3-LL & PORT-LL
904-SUN3-LL-03
Install the Lens
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
LED BODY
© 2011 Edge Lighting. All Rights Reserved.
1: Unscrew to remove the LED body from the trim.
A
SUN3-LL_
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
- The SUN3-LL & PORT-LL are the accessory step light kits
that are used with Sun3 and Port fixtures respectively.
- The SUN3-LL and the PORT-LL come with a Micro Louver
Lens for controlling the glare, a 20 degree beam tilt film
for controlling the beam light, a neutral density film (gray)
to reduce the light level to 50%, a warm white film
(amber) to convert the light level to 2700K and a very
warm white film (yellow) to convert the light level to
2500K.
- The SUN-LLH & PORT-LLH do not come with any lenses or
films.
TRIM
1
2: Using fingers remove the retainer ring inside the trim. If
necessary use a flat screw driver or pair of pliers to start.
B
2
TRIM
RETAINER RING
GLASS RETAINER RING
PORT-LL_
1
Zobrazit stránku 0
1 2

Shrnutí obsahu

Strany 1 - Install the Lens

NOTE:trim to be water proof. Do not remove the glass retainer ring which makes the Installation Instructions for STEP LIGHT KITS SUN3-LL & PORT-LL

Strany 2 - MANNER TO WORK PROPERLY

25: Align the set screw on the lens holder with the groove on the trim. Make sure that the spring clip side of the lens is in the opposite dir

Příbuzné modely Port LED Components

Komentáře k této Příručce

Žádné komentáře